http://satellite-board.de

hello everybody. i have matrix S and i need to replace the flash AT49BV1614. i have flash programmer so i can program both flash with it. what must i program into the boot flash and what in the software flash?can anyone help?

- New Flash solder.
- Program in the Flash at 0x00 the Bootloader over Jtag (From the *.bin File the 16byte long headers delete [0x00->0x0F]).
- The box bootet now.
- Bring afterwards firmware in again over RS232.

cu Oli

http://satellite-board.de/board/viewtopic.php?p=102020

i have a Jtag but i dont know if it works for here. on the receivers mainboard the jtug plug has 26 pin holes, on my jtag there are 20 pins( i use it for receivers like Metabox) . so if my Jtag is OK how must i put my Jtag into the receiver?