Das ging schon beim Non-Superset F1. Die Gertäe mußten nur die gleiche System ID haben sonst gabs den E-Id Fehler
Ich hab da bei Humax nochmal die
Beschreibung gefunden (ist schon lange her, daß ich so eine IRD Kopiererei gemacht habe):
Zitat:
*Download Instruction for IRD to IRD. ( F1 / F1-CI / F1-VA / F1-VACI )
1.Connect the two receivers using a serial cable.
2.The two receivers must be of the same type, i.e. F1-CI to F1-CI.
3.Switch on the master receiver, leave the slave receiver switched off.
4.The master receiver is the receiver you want to transfer data from.
5.Go to the STB/IRD Status menu on the master receiver.
6.Press the TV/Audio button on the front panel of the master receiver.
7.If there is no such button, then press the up arrow button on the front panel of the master receiver.
8.Press the "i" information button on the remote control.
9.Press the soundtrack button on the remote control (speaker with a question mark).
10.Press one of the following buttons on the remote control:
- press "1" if you want to transfer data only (bouquet and channel list).
- press "2" if you want to transfer the loader.
- press "3" if you want to transfer the software.
11.You will now see a message "UP-?"on the front display of the master receiver.
12.Switch on the slave receiver and the download should begin.
13.You will see "d-00" with the numbers increasing on the front display of the slave receiver. 14.You will then see "P-00" with the numbers increasing.
15.When the transfer is complete, you will see "End" on the front display of the slave receiver. 16.It is now safe to switch off the receivers. (do not switch either receivers off while the transfer is in progress)
Mit Option 2 konnte man damals wie gesagt auch die Bootloader kopieren, denn die waren beim Humax ja nie protected.
Da der IQG1 prinzipiell ja auf der F1 Serie basiert sollte das bei dem auch klappen.
Anmelden
Registrieren
FAQ
Suche
Impressum
